Connection and first start

Category: WIPERBOX

  1. Connect the device to a power source and wait for an audible signal that indicates the device is ready;

  2. Solution for erase:

    • one device:
      • Connect with the RJ45 cable to the “WIPE” socket located on the back of the WIPERBOX.
      • Connect the other end of the cable to the machine you want to erase

    • many devices:
      • Connect using the RJ45 cable to the “WIPE” socket on the back of the WIPERBOX.
      • Connect the other end of the cable into a free port on your switch.
      • Then you can connect the devices you want to erase to the other ports.

  3. Start the WIPERAPP (how to start WIPERAPP)

  4. Start erase (link to the movie)

  5. Log in to the administrator’s account (description of the admin interface)

  6. Generate a certificate erase report, go to https://panel.wiperapp.com/dashboard/reports and click Report button on the right side of table
Was this article helpful? Votes: 1